Cart contains {{shoppingcart.totalQuantity}} Item(s) Total: {{shoppingcart.subtotal}} {{shoppingcart.total}}

Carvin X60B EL34 High Gain Option

Our Products: Full Retube™ kits for Guitar Amps > Retube™ Kits For Carvin > Carvin X60B EL34 Amps & XT112

Price: $127.50

Carvin X60B EL34 High Gain Option

Product Details

Want all the gain you can get? This is the High Gain Option Retube Kit for the later X60B amps and the XT112 Combo that came with EL34's. The preamp section uses three handpicked High Gain ECC83S's with one balanced for the phase inverter in V3. The default power tubes are the JJ Electronic E34L’s but you can configure this kit to use the JJ EL34II's, EL34’s, KT77’s or Big Bottle 6CA7’s by clicking on the "Customize" button.

The Balanced High Gain ECC83S is located closest to the power tubes in V3.

Combo amps are very hard on tubes because of vibrations which can cause tube rattle with any brand of tube. If your amp is the combo version and you play by yourself in a quiet environment or record with your amp you may want to consider using the EuroDamper tube damper rings for the power tubes. These are available in the "Related Products” tab as a set of two. These will greatly decrease tube rattle.

Most of these amps are fixed bias but over the years many have been modded to be adjustable bias and after 1982 Carvin issued them with factory bias trimmers. If your amp is fixed bias without the mod then leave us a note in the comments box on the checkout page and we will send hotter tubes to help get the bias closer.

If your amp is adjustable bias then all you need to check and adjust the bias is a Multimeter if you use the Carvin method. For more accuracy you can also use a bias probe and a Multimeter, or our all-in-one Eurotubes "Pro One" bias probe that reads both the plate current and the plate voltage simultaneously. These are available under the "Related Products" tab.

You can use our Carvin bias video for reference which we did on a V3. If you're going to use the Carvin standby switch method then between 70 to 80mA is correct.

The video below explains the difference between bias probe types.

Related Products...

Check the check boxes next to the additional products that you would like to add to the shopping cart, then click on the "Add to Cart" button above. A check box is not shown if a product requires that you select an option or fill out a field. (

) indicates a required accessory.

Eurotubes “Pro One” Bias Probe for octal power tubes

Price $109.00

Eurotubes Octal Bias Probe

Price $30.00

Eurotubes 10 Gauge 3 foot Speaker Cable

Price $33.00

Eurotubes 10 Gauge 6 foot Speaker Cable

Price $42.00

© 1998 - 2014 Eurotubes Inc. All Rights Reserved
All text and images on this website may not be used without express permission.
All prices and product information subject to change without notice.