Cart contains {{shoppingcart.totalQuantity}} Item(s) Total: {{shoppingcart.subtotal}} {{shoppingcart.total}}

Carvin New Nomad-Belair-VT50 Blues Option #2

Our Products: Full Retube™ kits for Guitar Amps > Retube™ Kits For Carvin > Carvin Newer Nomad & Belair & VT50

Price: $173.00

Carvin New Nomad-Belair-VT50 Blues Option #2

Product Details

Want to drop the gain significantly in the soak channel? This is our Blues Option #2 Retube Kit and it contains a matched quad of JJ EL84's for the power section. For the front end we use two ECC832's for V1 and V2, a standard ECC83S's for V3 and a balanced ECC83S for the phase inverter in V4. This maintains your clean channel gain and drops the gain quite a bit in the soak channel for a more open sound. Great for Blues!

The Balanced ECC83S is located in V4 farthest from the input jack. The ECC832's are located in V1 and V2.

If your amp is either the Nomad or Belair Combo amp you may want to consider using the EuroDamper tube damper rings for the four EL84’s. Combo are very hard on tubes because of vibrations which can cause tube rattle with any brand of tube. These are available in the "Related Products” tab as a set of four and will greatly decrease tube rattle. ** Note: the wire tube retainers will not fit all the way over the damper rings.

These amps are adjustable bias. You can use the "Carvin method" with a Multimeter, or you can use one of our 9 pin bias probes with a Multimeter, or our all-in-one 9 pin "Pro One" bias probe (which reads plate voltage and plate current simultaneously). These are available under the "Related Products" tab.

You can use our Carvin bias video for reference which we did on a V3. The video shows using bias probes and also shows the Carvin Method for EL34’s and 6L6’s. Please Note; a setting of 80 to 95mA is good for EL84’s. If you’re using the JJ EL844’s a setting of between 60 to 72mA is good using the Carvin Method. If you’re using a bias probe then a setting between 20 to 24mA is good for EL84’s and a setting between 15 to 18mA is good for EL844's.

The video below explains the difference between bias probe types.

Related Products...

Check the check boxes next to the additional products that you would like to add to the shopping cart, then click on the "Add to Cart" button above. A check box is not shown if a product requires that you select an option or fill out a field. (

) indicates a required accessory.

Eurotubes “Pro One” Bias Probe for EL84 power tubes

Price $139.00

Eurotubes 9-Pin Bias Probe

Price $57.00

EuroDamper Small - Set of Four

Price $18.00

Eurotubes 10 Gauge 3 foot Speaker Cable

Price $33.00

Eurotubes 10 Gauge 6 foot Speaker Cable

Price $42.00

© 1998 - 2014 Eurotubes Inc. All Rights Reserved
All text and images on this website may not be used without express permission.
All prices and product information subject to change without notice.