Bugera 6260 Standard Retube Kit

There are two versions of this amp, if your amp is the "Infinium" model them it is self biasing and will set whatever tubes are installed right at 30mA per tube. This is a little on the cold side but sounds OK.

The non-Infinium amps are adjustable bias amps but unfortunately Bugera chosae to copy Peavey's bias scheme. The bias test points on these amps measure the negative bias voltage in the circuit and not the actual plate current. So the best and most accurate way to bias these amps is with a bias probe. Using the test points is a bit of a guess but it will usually get you on the outskirts of the ballpark. Please refer to the "Test Point Bias Video" which shows and describes this issue.

The cool thing about these amps is that you can use either our "Pro One" All-in-one bias probes or one of our 25.00 bias probes and a Multimeter to bias the amp without removing the amp from the cab. The probe will fit under one of the tubes while it’s in the cab so biasing is literally a 5 minute job.

EL34's, E34L's, KT77's, 6CA7's and 6L6GC's should all be biased between 35mA to 40mA. You can use the bias video we did on a PV JSX for reference.

The video below explains the difference between bias probe types.